The term is often used in situations where modifying a system's firmware without necessarily making any alterations to the machine's hardware has caused it to become inoperable. Fixing a brick generally comes in three steps; the first step is identifying the brick, the second step is launching homebrew , and the third step is using this homebrew to load a recovery tool. If a brick cannot easily be fixed, it is not recommended to trash the console. As Wii's are no longer in production, many people will probably be interested in a bricked console to repair or conduct research on.
Instead of trashing the console, sell it online or ask a community such as RiiConnect24 if they are interested in investigating the brick. To fix a brick, it must be identified first. If the System Menu boots fine, then the brick is simply a semibrick. If the health screen is the last screen seen, then the brick is either a banner brick or a mail brick. If "Error " appears on the screen, then it is an Error brick. If an Opera error shows, then it is a System Menu brick. If BootMii as boot2 still boots, then it is either a System Menu brick or an IOS brick , both of which have a similar fixing procedure.
If Priiloader is installed, and it boots, then this is likely a System Menu brick, and can easily be fixed. This causes the "Wii Setting" menu to fail and lock up so that you are unable to change any of the Wii's settings moving forward. But there are solutions for returning the Wii to the state it was in before this happened; one that doesn't require the use of any computer skills, while the other does.
Buy or rent a new Wii video game that is made by Nintendo and intended for use in your region i. Wait as the firmware checker in the video game checks that the Wii's firmware needs to be updated. If this does not happen, it means no firmware checker is on the disc and another game will have to be obtained to try it again. Follow the directions presented onscreen when the firmware checker has finished checking.
The firmware will now be updated. Often times, a Wii Remote will not be calibrated correctly causing the misaimed cursor. To re-calibrate the remote, place it on a table button side down for 10 seconds. After 10 seconds, point the Wii Remote back at the TV.
Check the cord on the Sensor Bar for any frayed wires or kinks, and verify that the Sensor Bar is free of obstructions. Check the button functionality, and that the Sensor Bar is operating correctly, by accessing the Wii Main Menu.
If there is no response, there is likely a problem with the Wii Remote. If the damage is in the middle of the wire, you can fix it on your own. Candle Method Because all the sensor bar really does is project infrared lights toward the remote, anything that sends out infra-red light is sufficient to work the Wiimote.
Many users report being able to use a pair of candles placed at either end of the TV with great success. Those are picked up by the Wiimote, and it triangulates off them to determine its position, and then the Wiimote sends that information back to the Wii.
So if you have two infrared lights and an independent power source, you can easily replace the sensor bar should it break. No, the two are technically identical, including width, height, light output, and blog.
0コメント