General 5 Here you will find general news, updates and information about Console Wizard. Console News 8 News, Info, Updates for consoles. Xbox News 4. Apple Macbook annual servicing to ensure your Macbook remains healthy. The fact of the matter is they are ultimately the same console. Jtag was possible on consoles that had a dashboard no higher than 2. This was because dashboards below 2. However this wasn't a simple procedure.
To Jtag a console required electronic components to be soldered to the consoles main board and an alternative dashboard programmed to the consoles main board to which enabled the Jtag and fully unlocked the console. This dashboard was nick named the " Blade " dashboard and was the dashboard on the Xbox console between - On dashboard higher than 2.
To over come the protection that was added to the later dashboards, a process called RGH Reset Glitch Hack was developed. It helps keep things a bit tidier. I Just got my JTaged xbox back and i need the next step i got paypal ill pay just email me at Camrondshaw gmail. Reply 8 years ago on Step 3. Dump again, then compare them. If there is still an error dump one more time and compare.
Depending on the address the block is at it might be okay to continue but I would STRONGLY advise against it because if you don't get a good dump then if something goes wrong which is very possible with non matching nands, if the error in the wrong sector you don't have a stock nand to flash back and lose your xbox.
If however you want to continue then look into using J-runner for making the ECC image. Reply 5 years ago. Making three dumps is the minimum required to reconstruct a dump IF you have any read errors. I suggest you work on your soldering skills as I have personally never had issues dumping, but then again I have a background in electronics.
A shorten the wires and redo soldering spots. The best tip I can give you is to heat up the spot you are going to solder for a second or to, then apply some tin and remove the tin and iron.
You always want to preheat the spot to solder on to to make the tin melt and then apply just a tiny speck extra to merge it with the tin on the wire you want to solder. I never use flux on solder spots like these, the tin you use is likely to have a resin flux core.
Reply 6 years ago on Introduction. By Superben51 Follow. More by the author:. Attachments Flash Tool. Attachments Falcon. Did you make this project? Share it with us! I Made It! Chameleon Mask by hugheswho in Halloween. Genaille's Rods by Wingletang in Education. Reply Upvote. Does this work for the corona? Not sure why you mention "flux" at the end, unless you are using the wrong type of solder. There's basically two types of solder: -Rosin core, for electronics.
Already has flux in it. Nothing else to add. Project D St8kout. GeorgeS St8kout. The Lost Puppy 5 years ago.
0コメント